Greatest reference in our business is our successful past

Teikoku Electric

 

TEIKOKU'S CANNED MOTOR PUMPS DESIGN

TYPE :F-V 

(BASIC TYPE WITH HOLLOW SHAFT)

Standard design of TEIKOKU Motor Pump. Most commonly used for a wide variety of applications. Internal circulation through hollow shaft requires no external piping.

FA-V TYPE
(BASIC TYPE WITH HOLLOW SHAFT)
Standard design of TEIKOKU Motor pump, but with adapter to increase motor and pump combinations.
F-V Type FA-V Type
 
RW / RV Type (Reverse Circulation)
vertical installation improves venting and minimizes bearing loads, recommended for low viscosity and high vapor pressures.
FW / FV Type (Hollow Shaft) Design with internal circulation, no ouside piping required
R TYPE
(REVERSE CIRCULATION)
Suitable for handling volatile fluids such as Ammonia , Freon, and other liquified gases, and for very low NPSH applications.
RW Type R Type
 
K-S TYPE
(FULL HEATING JACKET TYPE)
Suitable for handling fluids with high melting points.
K TYPE
(FULL HEATING JACKET TYPE)
Similar to K-S type, but for fluids with lower melting point.
KS Type K Type
 
D TYPE(SLURRY SEAL TYPE)
Suitable for handling fluids containing small amounts of fine solids. With mechnical seal to prevent solids from entering motor cavity.
XG TYPE
(GAS SEALED SLURRY TYPE)
Handles fluid with considerable slurry. Besides XG-type, SG-type with external flushing is also available.
D Type XG Type
 
G TYPE
(SELF-PRIMING TYPE)
Used for pumping fluids from underground tank or rail/tank truck unloading.
F-M TYPE
(MULTI-STAGE TYPE)
Higher head, higher efficiency pump. Besides F-M type, R-M (Reverse Circulation) type and B-M (High Temp-Insulation) type are also available.
G Type F-M Type
 
TYPE B
(HIGH TEMPERATURE DESIGN)
Suitable for handling high tempertaure fluids, such as heat transfer oils. Circualtion with external heat exchanger and motor jacket for cooling.
TYPE X
(HIGH TEMPERATURE DESIGN)
Suitable for handling high temperature fluids. Special motor coil insulation does not require any cooling jackets or heat exchanger. Therefore, space demand is very low.
B Type X Type
 
L TYPESpecial design for the use in Absoprtion Refrigeration. Internal circulation through hollow shaft requires no external piping. With inducer as standard to obtain low NPSH value. No base plate - pumpe directly mounted to the piping.
(ABSORPTION CHILLER)
L Type

Teikoku Electric

 

 

Teikoku Electric Ürünleri ile uygun rekabetçi fiyaları almak için müşteri temsilçimiz ile  http://www.imajteknik.com.tr/bize-ulasin veya Fiyat teklifi formunu doldurarak mesaj bırakmanız halinde satış muhendislerimiz en kısa zamanda sizinle irtibat kuracaklardır.

 

Teikoku Electric hakk?nda daha fazla bilgi i?in t?klay?n?z.