DANOTHERM / Heat Sink Resistors
DANOTHERM / Heat Sink Resistors
Heat sink resistors achieve the fully load capability when the resistor is mounted on a heat sink.Traditional types are wirewound resistors mounted in aluminum profiles with an organic insulation material. This construction ensures an increasing wattage compared to the mechanical outlines and in the same a time low hot spot on the aluminum surface. These types are optimized to high average loads (including snubbers). The pulse load capability is relatively low due the small outlines and is limited by the organic insulation material.
ALPHA Brake Resistors specialty the Flat Pack Types CCH and CDH will get an enlarged load ability when mounted on a heat sink. Since these types are constructed for pulse load they should be preferred in cases where pulse loads are expected.
The Ohmega High Voltage Snubber Resistor shown on the picture is a heat sink resistor designed for mounting in a groove or in a hole in a heat sink.
HSD
All-purpose Heat Sink Resistors
Terminals vertically
Power Range: 40W - 320W Steady state
HSF
Flat profile Heat Sink Resistors
Terminals horisontal
Power Range: 40W – 320W
Steady state.
HS Standard Heat Sink Resistors
Designed for Heat Sink mounting. Low ohmic values down to R005
HSCC Thick Film Heat Sink Resistors
POWER THICK FILM RESISTORS are supplied in a patented MODULAR construction. Suitable as balancing resistors in capacitor banks in frequency drives
Heating / Dehumidifying Resistors
HSH
Large surface aluminium housed resistor which disposes of heat without the use of additional heat sink
DANOTHERM / Heat Sink Resistors Ürünleri ile uygun rekabetçi fiyatları almak için müşteri temsilcimiz ile http://www.imajteknik.com.tr/bize-ulasin veya Fiyat teklifi formunu doldurarak mesaj bırakmanız halinde satış muhendislerimiz en kısa zamanda sizinle irtibat kuracaklardır.
DANOTHERM / Heat Sink Resistors hakkında daha fazla bilgi için tıklayınız.